Andis

UltraEdge No.7Fc/3.2mm – FREE only with certain Andis Clippers

£0.00

Andis offers one of the largest ranges of snap-on blades with a choice of traditional steel and cooler running ceramic cutters.

The UltraEdge range are made from carburized steel with a hard wearing chrome finish, to extend blade life and resist corrosion. 

Available in a range of sizes, fully compatible with all Oster & Andis professional clippers.

Ideal for use with blade guide comb attachments.

Out of stock

SKU: 4022-042 Category:

Oiling & Lubrication:

are essential to keep your clipper blades in good working order.  As such, we recommend applying a few drops of oil before you start clipping.

By adopting this simple 3-2-1 approach, you’ll be able to keep your blades cutting smoothly.  If you’re clipping with the same blade for longer than usual, reapply oil and/or a spritz of coolant spray every 10-15 minutes.  This will help control blade surface temperature and prevent clipper rash and skin irritation.  Applying oil little and often is usually the best approach and, will prevent your blade from getting choked with hair clippings, grease and dander which, will affect its cutting performance.

Cleaning & Flushing:

are equally important to prolonged the working life of your blades.  As such, we recommend a daily regime to remove any build-up of contamination and keep your blades cutting like new.

If your blade starts to drag, leaving clipper lines, this often means the blade has become choked with hair clippings, grease and dander.  To remedy this, submerge the blade in a shallow dish of cleaning solution, allowing the clipper (still running) to flush out any contamination trapped beneath the cutting blade.  Always keep the blade parallel with the surface of the solution and, never submerge the clipper itself.  Allow the clipper to run for 30-60 seconds, then lift and tilt the blade, allowing any excess fluid to drain away.  Wipe the outside surface with a clean dry cloth and, reapply blade oil before clipping again.

Dog Grooming Clipper Blade Chart
Working with our friends at The English Groomers Group, we’ve produced a handy blade guide chart to explain where and when to use specific blades.  This can be found in our catalogue but, is also available as a handy laminated poster that can act as a useful daily reminder or training aid.

Reviews

There are no reviews yet.

Be the first to review “UltraEdge No.7Fc/3.2mm – FREE only with certain Andis Clippers”

Your email address will not be published.

You may also like…